238

BORNIT® Edge Sealant Hot

bitumen | road | asphalt road construction | edge sealing | sealing
BORNIT
Short information
  • hot applied bitumen compound
  • for edge sealing
  • sealing of the higher edge in asphalt road construction
  • according to TL Sbit-StB 15
  • processing temperature +150 °C to +170 °C
  • sprayable (at least 4mm nozzle)
Product
Colour
Content
Edge Sealant Hot
black
25 kg / box
sufficient for:
Order-No.
EAN code
euro pallet
approx. 62,5 linear metre
6800000724
4 017228 00751 9
24 box
Consumption
  • edge sealing:
  • horizontal surfaces: min. 1,5 kg / m²
  • inclined surfaces: min. 4,0 kg / m²
  • (several working steps, if applicable)
Storage note
  • protect cardboard boxes from sunlight and moisture
  • in originally sealed containers storable for 12 months

Status technical data sheet
08 December 2020

Areas of application
BORNIT® Edge Sealant Hot is used for edge sealing (sealing of the somewhat higher edge) in asphalt road construction according to ZTV Asphalt-StB 07 against penetrating water.

Processing
The surfaces to be treated must be dry, clean and frost-free. Residues of oil, grease and soil as well as loose particles must be removed. Take BORNIT® Edge Sealant Hot out of the packaging and place it into the melting container. Melting must be undertaken under stirring and under temperature control (thermostat), in order to avoid local overheating of the material. Once the processing temperature (approx. 150-170 °C) has been reached, the hot compound is uniformly applied over the entire surface using suitable spraying equipment (at least 4 mm hot nozzle or valve). Application must be undertaken in several working steps and layers up to the respective overall application quantity.

Consumption
edge sealing:
horizontal surfaces: min. 1,5 kg / m²
inclined surfaces: min. 4,0 kg / m²
(several working steps, if applicable)

Product data in brief
Product type
bituminous sealing compound
Base
bitumen, fillers
Density at +20 °C
1.22 g/cm³
Softening point acc. to cone/ring
≥ 55 °C (EN 1427)
Consistency
solid, in heated state liquid
Colour(s)
black
Application
sealant heater and pouring can
Storage
protect cardboard boxes from sunlight and moisture
Shelf life
in originally sealed containers storable for 12 months
Hazard class according to ADR
keine
Flash point
220 to 230 °C

Cone penetration at 25°C
50 - 60 (EN 13880-2)
Flashpoint (COC)
220 to 230°C (EN 22592)
Melting temperature
approx. 150 - 170°C

Health and fire protection, occupational safety
For information on handling, safety and ecology, please refer to the current safety datasheet.

Storage
The product can be stored for 12 months. The cardboard boxes must be protected from direct sunlight and moisture!

Disposal note
Only recycle completely empty, cleaned containers. Material residues can be disposed of according to AVV-ASN: 060299 (consumed alkaline solutions (alkalis)).

Note
The above information replaces all previous technical information about the product. Thus, this information is no longer valid. The details have been compiled according to the latest state of application technology. Please observe, however, that, depending on the state of the construction object, deviations from the method of application suggested in the datasheet may be required. Unless agreed otherwise in individual contracts, any information contained in the datasheet shall be non-binding and thus does not represent an agreed product constitution. We reserve the right to any changes in the information contained in this datasheet anytime.
recommended, personal protective equipment: