BORNIT^® Rubber Scraper

status technical data sheet

4th October 2021

Areas of application

for removing BORNIT^® Asphalt Pore Sealer for sealing pores on porous surfaces.

Type and properties

Puller with hard-wearing rubber lip, for pulling liquid substances on flat surfaces such as concrete, asphalt etc. - the handle must be ordered separately.

Advantages

Surface

The subsurface can be porous but not uneven. When pulling it off, it must be ensured that the rubber lip lies flat. Small bumps can be evened out by the rubber, larger depressions cannot.

Processing

Place the rubber slider on the surface and pull it off with pressure on the handle at a slight angle to the direction of pull. If liquids leak on the side of the rubber lip, repeat the process as often as necessary.

Layer thickness control

Pull tightly over the grain / surface - max. material application for BORNIT^® Asphalt Pore Sealer 0.5 mm!

Product type

rubber scraper

Base

rubber lip, aluminium clamp

colour(s)

black, silver

Cleaning

BORNIT^® MultiClean Spray, BORNIT^® MultiClean or BORNIT^® Bitumen Cleaner

storage

store dry and with cleaned rubber lip

Hazard class according to ADR

keine

Width

60 cm

Clamping unit

aluminium

Material of the lip

rubber

Handle mount

ø ca. 24 mm

Health and fire protection, occupational safety

To ensure safe handling of the product, the physical, safety, toxicological and ecological information provided online, the information in the current operating instructions and the additional information on the label must be read and followed before purchasing or using the product! The applicable regulations, ordinances and laws must be complied with.

In case of doubt, please contact the BORNIT^® application technology department or the BORNIT^® service hotline on +49 375 2795 123.

Storage

store dry, cleaned

Note

The information set out above supersedes all previous technical information relating to the product. The previous information is therefore no longer valid. The details have been compiled in accordance with the latest state of the art in application technology. Please note, however, that depending on the condition of the building, it may be necessary to deviate from the working method recommended in this data sheet. Unless otherwise agreed in an individual contract, all information contained in this data sheet is non-binding and therefore does not constitute an agreed product specification. We reserve the right to make changes to the information contained in this data sheet at any time.

The product illustrations are to be understood as examples. No legally binding claim can be derived from them. We reserve the right to make changes to the product’s appearance.

Our packaging complies with the relevant legal requirements and with Regulation (EU) 2025/40 on packaging and packaging waste (PPWR). The technical documentation in accordance with Annex VII is available and can be provided on request by email to info@bornit.de.